| Processor Support |
- Dual Intel® Xeon™ processor in the Socket 604 INT3/FCPGA package
- 533-megahertz (MHz) Front side bus
- Dual Intel® Xeon™ Prestonia (and future Nocoma) processors
|
| Chipset |
Intel E7501 chipset
- E7501 North Bridge
- P64H2 I/O Bridge
- ICH3-S South Bridge
|
| Memory Support |
Support for up to six DDR266 compliant registered ECC DIMMs providing up to 12 gigabytes (GB) of memory, when 2G DIMMs become available and have been tested (supports DDR200 modules when 400-MHz processors are installed)
Note: 400 MHz processors & DDR200 DIMMs will function in the motherboard. However, neither has been tested and they are not supported. |
| PCI Bus |
Three separate and independent PCI buses:
- Segment A: 32-bit, 33-MHz, 5-volt (V) (P32-A) with a 2D/3D graphics controller as an embedded device: ATI Rage XL Video Controller with 8 megabytes (MB) of memory
- Segment B: 64-bit, 133-MHz, 3.3-V, PCI-X (P64-B) supporting the following configuration:
- One PCI I/O riser slot capable of supporting full length PCI add-in cards
- Dual-channel Intel 10/100/1000 82546EB Gigabit Ethernet Controller
- Support for 5-volt PCI cards through an optional 5-volt riser card
- Segment C: 64-bit, 133-MHz, 3.3-V PCI-X (P64-C) supporting the following devices:
- One PCI I/O riser slot capable of supporting low-profile PCI add-in cards
- Dual-channel SCSI with Zero Channel RAID (ZCR) and host RAID support Note: The onboard HostRAID must be disabled in order for a ZCR controller to operate properly. Also, the ZCR controller can only be installed in the bottom slot on the low-profile riser card. Gateway does not provide support for ZCR controllers.
|
| LPC Bus Segment |
Low Pin Count (LPC) bus segment with two embedded devices:
- Platform Management Controller (PMC) providing monitoring, alerting, and logging of critical system information obtained from embedded sensors on the server board
- Super I/O controller chip providing all PC-compatible I/O (floppy disk, serial, keyboard, mouse)
|
| X-Bus Segment |
X-Bus segment with one embedded device:
- Flash ROM device for system BIOS: Intel 32-megabit 28F320C3 Flash ROM
|
| USB Ports |
Four external USB 1.1 ports with an additional internal header providing two optional USB 1.1 ports for front panel support |
| Serial Ports |
One external low-profile RJ45 serial port; an internal header is also available providing an optional serial port |
| One IDE connector |
supporting one or two ATA-100 compatible devices |
| System Fans |
Support for up to seven system fans |
| Status LEDs |
Fault/Status LEDs throughout the server board |
| Sever Management Support |
Multiple server management headers providing on-board interconnects to server management features |
| SSI-Compliance |
SSI-compliant connectors for SSI interface support: front panel, floppy disk, and ATA-33 |
g!2k~$(KGrHgoOKkYEjlLmY4pPBK,Ol2QSyQ~~_1.JPG?set_id=8800005007)
